Pulsar Thermal Zeroing Target w/Heat Pad - 10pk

Ingredients: iron powder, activated carbon, vermiculite, salt, resin, water.

To use these heated targets, follow the steps below:

• The heat pack is air-activated, do not open the pad packaging until you are ready to use it.
• Open the packaging and take out the heat pad.
• Do not cut or damage the heat pad while taking it out.
• Remove the paper strip from the back side of the heat pad to expose the adhesive surface.
• Stick the heat pad with the adhesive side to the center of the paper target marked with circle.
• There is no need to shake the heat pad, it will warm itself up in 3-5 minutes.
• Attach the paper target to the desired location.
• Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize thermal view, so that thermal pad is clearly visible.
• Perform zeroing procedure as described in the user manual of your thermal imaging device.
• With the help of the round shape and small diameter of the pad, deviations of point of impact can be eliminated in just a few shots.